价格:￥0.00/套
起订:1套
发货:2天内

发送询价

高清手表使用说明一、前言感谢您购买本产品，这份手册能引导您正确使用本产品及随本产品所附属的应用程序。在您使用本产品及随本产品所附属的应用程序前，请认真阅读说明书，以确保您能够正确、轻松地操作本产品。二、功能概述：● 录分辨率1280*720，每秒30帧。● 拍分辨率（1600*1200可选）。●录格式：AVI格式●拍照格式：JPEG格式● USB传速：1.1（Hs）●内存可选：512MB/1GB/2GB/4GB/8GB/16GB/32GB●支持视频录音功能●内置锂电池，可连续工作。●Windows ME/ 2000/ XP/ Mac OS 9.2.2 或以上版本的操作系统无需安装驱动程序（Windows98系统需要安装驱动程序）●摄像头功能：可作为标准电脑摄像头使用，需要安装随机提供的驱动程序。 三、电池低电与充电：1、本摄像手表内置可充电式锂电池，可将手表上的USB插头与充电器连接或插入电脑的USB接口即可充电。正确连接好后，像手表红灯蓝灯亮起红灯熄灭蓝灯慢闪烁，表示正在充电的状态；当蓝灯恒亮时，表示电已充足，此时请停止充电。2、在录像或拍照时，如电池电量不足则蓝灯快闪，摄像机会自动关机，关机前系统会自动保存文件，然后再关机，以确保文件的安全。四、外型与按键：1、开机/录/拍键：长按开/关机，短按录。2、模式键：短按模式键红灯亮起拍照待机。3、USB接口4、摄头5、指示灯6. MIC(录音)7.时钟调动键8.指南针9．组合复位键：先按住模式键不放，再按开机/录/拍键五、操作方法：1、开机：在关机的状态下，长按 开机/录/拍照键 两秒钟左右红、蓝灯同时亮，红灯灭蓝灯长亮进入待机的状态。2、关机：在待机或录像的状态下，长按 开机/录像/拍照键 红灯会闪烁三下并关机；在待机的状态下不作任何动作3分钟后会自动关机。3、录：在待机状态下，短按 开机/录/拍键 蓝灯闪烁三下后熄灭，表示开始录像；在录像时短按任意键蓝灯都会闪三下，提示正在录中；在蓝灯闪烁时短按 开机/录像/拍照键 会保存当前录像的文件并进入到待机的状态。（注：如磁盘空间不足时红蓝灯一起快闪，约五秒后摄像机会自动关机。）4、拍：在待机的状态下短按模式键 红灯亮起，短按开机键闪一次，表示已完成一次拍，并将照片以JPEG格式保存。5、单独录音：在待机状态下短按模式键（红蓝灯亮起）再按开机键红灯慢闪进入单独录音此时短按模式键切换下一个模式同时录音文件已保存。6、复位键：如出现死机现象，请按组合复位键重启（先按住模式键 不放，再按 开机键）。六、驱动安装：1、U盘驱动程序仅对Windows 98的用户, 将随机附带的CD安装驱动程序到你的电脑并重启后生效。Windows ME/ 2000/ XP/ Mac OS 9.2.2 或以上版本的操作系统无需安装驱动程序。2、摄像头驱动程序安装将随机附带的CD放入光驱，安装摄像头驱动程序（PC-Camera 安装程序.exe）到您的电脑。七、连接电脑：1、检查您的计算机上是否有USB端口（有些电脑能找到后端的USB端口而找不到前端的USB端口，必要时请与系统供应商联系）。2、使用本机配备的USB延长线连接到PC USB接口，正确连接后，您可在“我的电脑”上找到“可移动磁盘”的盘符；当摄像手表连接到PC后，摄像手表作为PC的移动硬盘已经开始工作。这时您就可以通过电脑非常方便的查看录像文件、传输、拷贝、粘贴和删除数据（音频、视频文件等）,也可以存贮非音乐文件。3、摄像头功能：在摄像手表开机的状态下，插入USB线将手表与电脑连接，正确连接后红灯长亮，并在您已安装驱动程序的情况下，您会在“我的电脑”找到“Standard Camera”的设备，此时您就可以将本机作为摄像头使用了。4、录像日期与时间的修改：1.将本机关机状态与电脑连接，在我的电脑出现可移动盘，打开随机提供的更新时间工具（WriteTime.exe），直接“开始更新”按钮，工具自动把电脑的系统时间更新到摄像手表上，然后断开电脑连接并将本机正常开机蓝红灯快闪熄灭即可。2.将本机关机状态下与电脑连接，在我的电脑出现可移动盘，然后再可移动盘建（TIME）文档，打开（TIME）文档建修改时间如：（2010.11.13 10:20:00）然后安全退盘开机蓝红快闪熄灭即可。5、弹出USB设备：a. 双击 Windows界面的“安全删除硬件”图标（右下角绿色箭头）。b. 在“安全删除硬件”对话框中选择“停止”。c. 选择要停止的设备，选择“确定”，设备被安全删除，右下角绿色箭头处弹出“安全删除硬件”信息提示框“‘USB量Mass Storage Device’设备现在可安全地从系统移除”。d. 关闭“安全删除硬件”对话框。e. 断开播放器与PC间的连接。八、常见故障

不能开机	电池是否没电量 请充电
不能正常下载或上传文件	1. 检查播放器与PC间的USB连接线是否有损坏，连接是否正确； 2. 确认驱动程序是否安装妥当(在Windows 98操作系统下) 3. 确认播放器是否有足够的空间存贮音乐文件。

RD77 HD DVR Watch ManualA. PrefaceThanks for purchasing this product.This user manual will guide you the right operation of this product and accessorial software. Before you using the product and accessorial software,please read the user manual carefully,to make sure using this product correctly and easily. B. Function overview● Video resolution: 1280*72030fps● Photo resolution:1600*1200(Optional)● compass function●Video format:AVI Photo format:JPG● USB speed: 1.1（Hs）●Optional flash memory: 512MB/1GB/2GB/4GB/8GB/16GB●Support audio/sound recording.（with a extra waterproof cap for microphone button）●Built-in Li-battery for working Continuously●OS: Windows ME/ 2000/ XP/ Mac OS 9.2.2orhigher version that needn’t install driver (Windows98 needs to install driver) ●PC camera : can be used as standard PC camera,need install the provided driver.C. Low battery and charge:1.This camera watch has built-in rechargeable li-battery,can charge it by connecting the watch USB interface with adapterorcomputer USB interface. After the right connect, the red light and blue light both turn on, and then red light turns off while blue light flashes slowly indicating it’s charging；when the blue light is constantly on, indicating it is fully charged, please stop charging then.2.When video recordingortaking photos,bule light will flash quickly if low battery,camera will turn off automaticly. Before the camera turns off, the file will be saved firstly to make sure the safety of the file.D. Apperance and Button:1. Power/Video button: pss and hold down the button to turn on/off, short pss it to record video.2. Mode Button: short pss the button to change function mode.3. USB interface4. Camera Lens5. LED Indicator6.Microphone7.Time setting8. Compass9. Reset button:hold down the Pohoto Taking Button,then pss Power/Video button.E. Operation method1.Turning on the camera : Press and hold down the Power/Video button for two seconds, the red light and blue light will both turn on at the same time，then the red light turns off while the blue light keeps on, it indicates power on and enter into the standby time mode.2.Turning off the camera: In the standby/video mode，pss and hold down the Power/Video button, the red light flashes for three times and then turns off；If the camera is not operated in 3 minutes after power on, it will be power off automatically.3.Recording a video: In the standby time mode, short pss the Power/Video button, the blue light flashes for 3 times and then turns off,，video recording begins, In the meantime, Short pss any button, the blue light flashes for three times, it reminds you that it’s recording the video；And when the blue light is flashing, short pss the Power/Video button, a video will be saved and enter into the standby time mode.(Note: If the camera is out of memory, the red light flashes quickly, about 5 seconds later, the camera turns off automatically. )4.Taking a photo:In the standby time mode when red light is on, short pss the Power/Video button, the red light flashes once, a photo will be saved as a JPG format.5.Separate Sound recording: In the standby time mode, short pss the Mode Button, when the red light and blue light both turn on, short pss Power/Video button, the red light will flash slowly, sound recording begins. In the meantime, short pss Mode Button to change into another mode and a sound clip will be saved.6.Reset button: If the system crashed, pss the Reset buttons to restart( firstly pss and hold down the Mode Button, and then pss the Power/Video button).F. Installing the driver1. only for windows 98 system, it comes with an addtional CD install driver to your PC, it will come to effect after restarted the PC. No need to install the driver for Windows ME/2000/XP/Mac OS 9.2.2 systemsorabove version.2.Put the CD accessory to the CD-ROM to install the PC camera driver(WDV_020_PC-Camera.exe) to your computer.G. Connecting with computer1.Check and see if your computer has the USB port( some PC doesn’t have the front side USB port, you can just find the back side USB port. Please contact the PC system supplier if needed).2.Use the USB cable connecting to your PC USB port, after it is connected,you can find a ‘ removable disk’ on your computer. When you connect the watch camera to the PC, the watch begins to work as a removable disk. You can check the video, transmit, copy, attach and delete the data easily( video、audio etc), you can also save the non-music documents.3.PC camera functionIn power on mode, connect the watch to the PC with the USB cable, after connected, the red light turns on，You will find the ‘standard camera’ PC camera device on my computer(After installed the driver), then a PC camera can be used.4.Updating the date and time of the videoa. In the power off mode, connect the watch with your computer，the “ moveable disk’ will be appeared in the root of my computer, open the accessorial time updatetool(WriteTime.exe)，directly click on ‘start update’ button, the tool will updatetime of the watch camera according to the PC, and then disconnects the watch from the computer and turns on the the watch camera。b. In the power off mode, connect the watch with your computer，the “ moveable disk’ will be appeared in the root of my computer， create a new TIME.txt in the moveable disk, open the TIME.txt and imput the date and time ‘ such as 2010.11.13 10:20:00’ and save it, and then disconnects the watch from the computer and turns on the the watch camera. Then the blue light and red light will both flash and turn off.5. Quit USB device:a. Double-click the Windows Interface "Safely Remove Hardware" icon (lower right corner of the green arrow).b. select"Stop" in "Safely Remove Hardware"dialog box.c. Choose the device to stop, click "OK", device quit safely,"Safely Remove Hardware" dialog box will show ’USB Mass Storage Device can now be safely removed from the system’ in the lower right corner of the green arrow.d. Close"Safely Remove Hardware"dialog box.e. Disconnect the USB device from computer.H. FAQ

Can not turn on	Check if the device power is run out,please charge the battery
Can not upload/download files normally	1. Check whether the USB cable between the USB device and the PC is damagedornot,and the connection is rightornot. 2. check whether the driver is installed properlyornot(in Windows 98 system); 3. Check whether there’s enough storage space to save the file.